Demonstrate the lockout and tag-out procedure

• Shut down the equipment
• Disconnect the power supply or have it disconnected
• Note clearly on a plastic tag-out tag the problem with the equipment
• Hang a ‘lock-out’ tag to the ignition switch and ensure that it is visible
• Advise the supervisor ASAP of the problem
• Follow the instructions of the supervisor to either remove the equipment or leave it as is
• Secure the broken equipment with a padlock
• Retain the key until the machinery is repaired.

100% of assessment criteria

Use a ladder(s) safely

• Check that the ladder is in good repair i.e. no broken or damaged rungs
• Ensure that the ladder is suitable for the job being performed i.e. not too long and not too short
• Put the kicker at the bottom of the ladder.
• Check that the ladder is on a solid surface and that it doesn’t slip or slide
• Climb the ladder, with a ‘spotter’ holding it
• Tie the ladder at the top to a secure/solid location. A fastener can be used if necessary
• If climbing onto a roof, the ladder must be a minimum of three feet beyond the roof or work area.

100% of assessment criteria